Brother PE 300S operation manual Starting and Stopping Sewing, START/STOP button, Foot controller

STARTING AND STOPPING SEWING

“START/STOP” button

1.Place the fabric under the presser foot, lower the presser foot, and then press the “START/STOP” button. The sewing ma- chine starts sewing.

*Adjust speed by sliding the speed control lever.

* Sewing continues at low speed while the button is pressed.

2. And then press it once more to stop the machine.

Foot controller

CAUTION

Do not allow fabric pieces and dust to collect in the foot controller. Doing so could cause a fire or an electric shock.

1. Turn the power off and plug the foot controller plug into the jack on the back of the machine.

* The foot controller can not be used during machine em- broidery.

1

1 Foot controller

2 Foot controller jack

2

2.When the foot controller is depressed lightly, the machine will run at a low speed.

*The speed selected by the speed control lever on the body of the machine will be the maximum speed of the foot con- troller.

1 Faster

3. When pressure on the foot controller is released, the machine

1will stop.

*When the foot controller is being used, the “START/STOP” button has no effect on the sewing.

Note (For U.S.A. only) Foot controller: Model N5V

This foot controller can be used for sewing machine model PE- 300S.

	Contents
	Setting Up
Operation	Machine	Basic Sewing
	Utility Stitches
	Embroidering
	Maintenance
	Troubleshooting
	Messages	Error
	Sewing Chart
in Machine)	(Programmed	Patterns
	(Memory Card)	Patterns

23