Brother XL-5061, XL-5060, XL-5051, XL-5071, XL5050 For Users in the UK, EIRE, Malta and Cyprus only

XL5000us.book Page 2 Tuesday, November 11, 2003 9:25 AM

———————————————————————————————————————————————————————————————

FOR USERS IN THE UK, EIRE, MALTA AND CYPRUS ONLY

If this machine is fitted with a three-pin non-rewireable BS plug then please read the following.

IMPORTANT (in the United Kingdom)

Main supply (AC 230/240V, 50Hz)

DO NOT cut off the main plug from the equipment. If the plug fitted is not suitable for the power outlet in your home or the cable is too short to reach a power outlet, then obtain an appropriate safety-approved extension lead or consult your dealer.

BE SURE to replace the fuse only with an identical approved type, as originally fitted, and to replace the fuse cover.

If the main plug is cut off, be sure to remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the main power supply.

IMPORTANT (in the other countries)

If the available socket outlet is not suitable for the plug supplied with this equipment, it should be cut off and an appropriate three-pin plug should be fitted. With alternative plugs, an approved fuse must be fitted in the plug.

NOTE: The plug severed from the main leads must be destroyed as a plug with bared flexible cords is hazardous if engaged in a live socket outlet. In the event that the plug fuse is replaced, use a fuse approved by ASTA to BS 1362,

i.e., carrying the mark, rated as marked on the plug.

Always replace the fuse cover. Never use plugs with the fuse cover omitted.

WARNING: DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL WHICH IS MARKED WITH THE LETTER ‘E’ OR BY THE

EARTH SYMBOL , OR COLORED GREEN OR GREEN AND YELLOW.

The wires in this main lead are colored in accordance with the following code:

Blue Neutral

Brown Live

As the colors of the wiring in the main lead of this appliance may not correspond with the colored markings identifying the terminals in your plug, proceed as follows:

The wire that is colored blue must be connected to the terminal marked with the letter ‘N’ or colored black or blue.

The wire that is colored brown must be connected to the terminal marked with the letter ‘L’ or colored red or brown.

CONNECTING PLUGS AND MAIN POWER/SEWING LIGHT SWITCH

1

2

1.Connect the three-prong plug into the machine.

2.Connect the electrical supply plug into a wall outlet.

•When leaving the machine unattended, the main power switch of the machine should be switched off or the plug must be removed from the socket outlet.

2

The main power/sewing light switch turns the main power and sewing light on or off.

1Turn on

2 Turn off

•When servicing the machine, removing covers or changing bulbs, the machine must be unplugged.