![](/images/new-backgrounds/1040829/4082971x1.webp)
XL5000us.book Page 35 Tuesday, November 11, 2003 9:25 AM
5Sew from the bottom of the zipper toward the top on both sides. The needle should be positioned on the zipper side of the foot for best results.
6To sew the opposite side of the zipper, release the foot by raising the lever located at the back of the presser foot, position the zipper foot on the other side of the zipper and continue sewing using the notch on the other side.
CAUTION
●Make sure the needle does not hit the zipper during sewing. If the needle hits the zipper, the needle may break and you may be injured.
Gathering
|
|
| Stitch |
Stitch Name | Pattern | Length | |
|
|
| [mm (inch)] |
Straight Stitch |
|
| 4 |
|
| ||
(Center needle position) |
|
| (3/16) |
|
| ||
|
| ||
|
| ||
|
|
|
|
1SetStitch.the pattern selection dial to the Straight
2Loosen the tension of the upper thread so that the lower thread lies on the underside of the material.
3Sewstitches.a single row (or many rows) of straight
4Pull the lower threads to gather the material.
Darning
|
|
| Stitch |
Stitch Name | Pattern | Length | |
|
|
| [mm (inch)] |
Straight Stitch |
|
| Any |
|
| ||
(Center needle position) |
|
| |
|
| ||
|
|
| |
|
|
| |
|
|
|
|
1Place the darning plate on the needle plate. (On a machine equipped with a drop feed lever, lower the feed dogs by setting the drop feed lever to the up position.)
2SetStitch.the pattern selection dial to the Straight
3Put the section you want to darn under the presser foot, together with a piece of fabric for reinforcement.
4Remove the presser foot and presser foot holder, and then lower the presser foot lifter.
5Begin sewing by alternating between gently drawing the work away from you and pulling it toward you.
6Repeat this motion until the darning section is filled with parallel lines of stitching.
35