Bryant 353AAV manual

353AAV

Direct or Non--direct Venting — The Plus 90x can be installed as a 1 pipe/Non--Direct vent (except 140 size unit and in manufactured/mobile home installations) or 2 pipe/Direct vent furnace. All direct vent Plus 90x models can be installed in a manufactured (mobile) home when the optional kit is used. This provides added flexibility to meet diverse installation needs.

Insulated Blower Compartment —The acoustical insulation reduces air and motor noise to promote quiet operation.

Combustion Products Venting — The combustion--air and vent pipes can terminate through a side wall or through the roof when used with a factory--authorized vent termination kit.

Insulation — Foil--faced insulation in heat exchanger section of the casing minimizes heat loss.

Bottom Closure — Factory--installed for side return; easily removable for bottom return.

Filter — Cleanable filter with retainer is standard.

Blower Access Panel Switch — Shuts off all 115--v power through furnace components whenever blower access panel is opened.

Casing — One piece, seamless wrap--around construction of heavy, galvanized steel that resists corrosion.

Adjustable Blower Speed — For precise airflow selection of heating or cooling operation.

Monoport Burners — The burners are finely tuned for smooth, quiet combustion plus economical gas usage.

Slow Opening Redundant Gas Valve — Shuts off gas to burners if any of the valves fails to close completely for any reason. The slow opening feature reduces start--up noise from rapid ignition.

Quality Registration — The Plus 90x is engineered and manufactured under an ISO 9001 registered quality system.

Certifications — The Plus 90x Model units are CSA (A.G.A. and C.G.A.) design certified for use with natural and propane gases. The furnace is factory--shipped for use with natural gas. A CSA (A.G.A./C.G.A.) listed gas conversion kit is required to convert furnace for use with propane gas. The efficiency is GAMA efficiency rating certified. The Plus 90x meets California Air Quality Management District emission requirements. Refer to Vent Table, for elevation limitations.

BLOWER OFF-DELAY

24-V THERMOSTAT TERMINALS

3-AMP FUSE

LED OPERATION

& DIAGNOSTIC LIGHT

BLOWER SPEED SELECTION TERMINALS

115-VAC (L2) NEUTRAL CONNECTIONS

		BLOWER OFF-DELAY
T1			90150	120180			TWINNING AND/OR
DHUM							COMPONENT TEST
							TERMINAL
G
COM 24V							HUMIDIFIER TERMINAL
W								)
							(24-VAC 0.5 AMP. MAX
TIT2			PLT
		TEST / TWIN
R		HUH
SEC-2 SEC-1
COM		24VAC
		PL1
COM	24V
							TRANSFORMER	S
HEAT
	MTR						24-VAC CONNECTION
COOL		1
FAN	TAPS
SPARE 2 SPARE 1
EAC-2							PL1-LOW VOLTAGE
				EAC-1			MAIN HARNESS
							CONNECTOR
				L1	BL-1	PR-1	PL2
					EAC-1 TERMINAL
					(115-VAC 1.0 AMP. MAX0
			115-VAC (LI)				PL1-HOT SURFACE
			NUETRAL				IGNITER & INDUCER
			CONNECTIONS				MOTOR CONNECTION

A92505 A08345 A02172

2