Bryant 598B warranty Specifications, 024-A 036-A 048-A 060-A, B

Coastal installations.

Windy areas or where debris is normally circulating. Rooftop installations.

SPECIFICATIONS

UNIT SIZE-SERIES		024-A	036-A	048-A	060-A, B
OPERATING WEIGHT (Lb)		171	228	266	311
ELECTRICAL
Unit Volts—Hertz—Phase		208/230-60-1	208/230-60-1	208/230-60-1	208/230-60-1
Operating Voltage Range*		187-253	187-253	187-253	187-253
Compressor— Rated Load Amps		10.6	14.1	19.9	26.3
	Locked Rotor Amps	64.0	66.0	96.0	130.0
Condenser Fan Motor—Full Load Amps		0.5	0.8	1.1	1.1
Min Unit Ampacity for Wire Sizing		13.8	18.4	26.0	34.0
Min Wire Size (60°C Copper) AWG†		14	14	10	8
Min Wire Size (75°C Copper) AWG†		14	14	10	10
Max Wire Length (60°C) (Ft)‡		57	43	77	91
Max Wire Length (75°C) (Ft)‡		55	41	73	56
Max Branch Circuit Fuse Size**		20	30	40	50

COMPRESSOR AND REFRIGERANT
Compressor—	Manufacturer			Bristol
	Type		Reciprocating
Temperature and Current Protection			Internal Overload
Refrigerant—	Type		Puron® (R-410A)
	Amount (Lb)	6.0	8.9		11.5	13.1
Metering Device			Puron Balance Port Hard Shutoff TXV
CONDENSER COIL AND FAN
Coil—Face Area (Sq Ft)		10.8	18.2		18.2	18.2
Fins per In.—Rows—Circuits		25-1-2	25-1-3		20-2-5	20-2-5
Fan Motor—HP and RPM (PSC Type)		1/15 and 825	1/8 and 825		1/5 and 825	1/5 and 825
Volts—Hertz—Phase			208/230-60-1
Condenser Airflow (CFM)		1500	2500		3000	3100
OPTIONAL EQUIPMENT
Support Feet			KSASF0101AAA
Coastal Filter			KAACF0801MED
Bi-Flow Balance Port TXV (Hard Shut-off)		KSATX0201PUR	KSATX0301PUR		KSATX0401PUR	KSATX0501PUR
Thermostat, Auto Changeover,
Non-Programmable, °F/°C, 1-stage heat/			TSTATBBNAC01-B
1-stage cool
Thermostat, Auto Changeover,
7-Day Programmable, °F/°C, 2-stage heat/
2-stage cool in AC mode, 3-stage heat/			TSTATBBP2S01-B
2-stage cool in HP mode
Thermidistat Control, Programmable/Non-			TSTATBBPRH01-B
Programmable Thermostat with Humidity Control
Outdoor Air Temperature Sensor			TSTATXXSEN01-B
Backplate for Non-Programmable Thermostat			TSTATXXNBP01
Backplate for Programmable Thermostat			TSTATXXPBP01
Thermostat Conversion Kit (4 to 5 wire)—10 Pack			TSTATXXCNV10

* Permissible limits of the voltage range at which the unit will operate satisfactorily. Operation outside these limits may result in unit failure.

†If wire is applied at ambient greater than 30°C (86°F), consult Table 310-16 of the NEC (ANSI/NFPA 70). The ampacity of nonmetallic-sheathed cable (NM), trade name ROMEX, shall be that of 60°C (140°F) conductors, per the NEC (ANSI/NFPA 70) Article 336-26. If other than uncoated (non-plated), 60 or 75°C

(140 or 167°F) insulation, copper wire (solid wire for 10 AWG and smaller, stranded wire for larger than 10 AWG) is used, consult applicable tables of the NEC (ANSI/NFPA 70).

‡Length shown is as measured 1 way along wire path between unit and service panel for a voltage drop not to exceed 2%. ** Time-delay fuse or circuit breaker.

NOTES: 1. Copper wire must be used from service disconnect to unit.

2.All motors and compressors contain internal overload protection.

3.This product may not be used in low-ambient applications below 55°F outdoor ambient.

OPTIONAL EQUIPMENT DESCRIPTION AND USAGE (Listed Alphabetically)

1.Coastal Filter

A mesh screen inserted under the top cover and inside the base pan to protect the condenser coil from salt damage without restricting airflow. SUGGESTED USE:In geographic areas where salt damage could occur.

2.Support Feet

Four stick-on plastic feet which raise the unit 4 in. above the mounting pad. This allows sand, dirt, and other debris to be flushed from the unit base; minimizes corrosion.

SUGGESTED USE:

—4—