BT 1050 manual Plug the mains adaptor cord into Back of the base unit

Plug the mains adaptor cord into

4 the back of the base unit

To prevent the cable being pulled out by accident, route it through the channel on the underside of the base.

Mains power adaptor

The Freestyle 1050 must only be used with the

adaptor supplied.

Using any other adaptor will invalidate the approval

given to this apparatus.

SETTING UP

12V AC

PHONE LINE

Electrical storm warning

During periods of electrical storm, you are advised to disconnect your apparatus because damage may occur.

If a fault occurs during the 12-month warranty period and it is due to accidental or wilful damage (including lightning and electrical damage),

BT will not replace or repair free of charge.

Plug the 3 pin adaptor into the

5mains power socket and switch on

Your Freestyle 1050 begins the set up procedure.

–the message counter flashes ‘–’.

–the message counter then flashes 0.

–the pre-set outgoing message is ready to use.

Charge the handset battery for at

6least 12 hours

When you first use your Freestyle 1050, the rechargeable batteries in the handset need charging for 12 hours.

Place the handset on the base unit face down, ensuring the contacts are touching.

The CHARGING light on the base unit comes ON.

After the handset has been charged for 12 hours, your phone is ready for use.

As a rule, placing the handset on the base unit overnight will keep the batteries fully charged for all normal use.

The CHARGING light remains on until the handset is removed from the base unit.

When fully charged and in good condition, the handset battery will provide up to 6 hours continuous talk time or 72 hours standby.

If the handset battery is running low, the

BATTERY LOW light will flash every 10-15 seconds.

If you are making a call and the handset

battery is running low, the phone will beep every

10-15 seconds.

Place the handset on the base unit to recharge.

6