BT 60E Help

49

Help

The error light comes on and an error message

is displayed.

An error report is automatically printed. Press the

Stop button to reset the machine and check the

message against the Error Messages list, page 52.

If you run out of paper or ink.

Your PaperJet 60E will store incoming faxes in the

memory.

If you run out of paper or ink or the paper jams

during reception, or if you open the printer cover,

printing will stop and the fax you are receiving

will be temporaryily stored in the memory. Once the

problem has been resolved, your machine will start

printing again.

Replacement of cartridges (Code M 2191) are

available by telephone 0870 240 7285.

If there is a power failure

In the case of power failure, the fax machine will

keep the data for:

•numbers stored in the one-touch and speed

dial memories

•reports

Any documents stored in the memory will be lost.

When the power is restored your machine will print

out a report which shows the total number

of pages (both received and stored for sending) lost

from the memory.

Your machine doesn’t switch on

Check that the mains power is plugged in and

switched on.

The document cannot be inserted into the

document feeder

Check the size of the document. See page 16 for

correct sizes.

Fax documents are not sent

Check that the document is not jammed in the

machine.

The line may be busy. Your machine will retry

automatically 3 times at 2 minute intervals.

PaperJet 60e_se 6-06-2003 16:52 Pagina 49

Contents

Main 12 Month guarantee At a glance Page Page Key features In this guide Introduction Unpacking your PaperJet 60E For your records Safety information Setting up 6. Load paper 5Connect the mains power SET DATE/TIME AUTOMATIC RX 00 CHECK PRINT HEAD FORMAT: DD/MM/YY 7To set the date and time NOTE 8Install the starter print cartridge CHECK PRINT HEAD 9Automatic print quality test page # 10 CHECK PRINT OUT 1=EXIT 0= REPEAT H O 11 To set the position of your fax header Using your PaperJet 60E Sending faxes Setting the contrast and resolution To send a fax To select the default resolution setting TX RESOL. STD To dial and hear the progress of your fax call To redial the last number To dial using the handset To switch document retransmission on/off FAX SETUP RETRANS.DOC: OFF To send a fax at a pre-set time (delayed faxing) To change the details of a pre-set fax To fax from memory To broadcast a document To change, re-send or cancel a stored document Receiving faxes CHANGE PARAM? MEMORY TX AUTOMATIC RX TYPE FAX NUMBER Using the one-touch memories # To edit or delete a one-touch entry To send a one-touch fax Using the speed-dial memories To store a speed dial entry CODED SPEED DIAL TYPE SPEED NO. FAX NO. To edit or delete a speed dial entry TEL. NO TEL NO 01: FAX FAX Reports and lists To request immediate print-outs To switch automatic printing of delayed transmission on and off. To switch automatic printing of broadcast reports on and off To switch automatic printing of transmission and error reports on and off To make a phone call. Making and receiving phone calls To search through the speed dial entries TEL CALL CODE OR < > To make a speed dial call To put a caller on hold To dial a one-touch phone number Copying documents To copy a document 100% TEXT NORMAL To stop copying Using the answering machine LIFT HANDSET TO RECORD To record your OGM(s) and forwarding announcement RECORD OGM To switch the answering machine on/off To play back OGM 1 or OGM2 PLAY OGM #1 PLAY OGM #2 PLAYING To play your messages To delete individual messages To skip forwards or backwards through your messages To delete all messages that have been played back DELETE OLD MSG? To forward new messages To set Announce Only Recording capacity To set the maximum message length To switch Call screening on/off To switch standard voice announcements on/off To lock/unlock the answering machine To change your Remote access code ACCESS CODE TYPE CODE (0-9): 1234 PLAY UNLOCK Remote access 1234 To operate the answering machine from another phone ANNOUNCE ONLY To switch toll saver on/off ON TOLL SAVER OFF Additional features To set the print area of a document To adjust the ringer volume To set the number of rings before your fax machine takes a call To receive a document longer than the paper size To adjust the duration of the phone call alert beeps To switch remote start off/on To change the remote start code To adjust the volume of the buzzer To switch the fax tones on and off To adjust the loudspeaker volume To adjust the speed a fax is sent at To switch ECM mode on/off Polling To poll a document from another fax machine POLLING RX TYPE TIME TYPE FAX NUMBER To set a document for polling by another fax machine To change a polling time and number To cancel polling To change the silence detection time Caller Display Call Sign (Distinctive ringing) To learn the ring melody Connecting to a switchboard To set the dialling mode and access number Using the External button E To switch dialling mode during a call Help Page Error codes ERROR CODE Other problems may be accompanied by a display of and a number. Check the number against the list below. Error messages POLL. RETRY nnn REMOVE DOCUMENT, PRESS RX ERROR RX IN MEMORY Beeps Memory capacity Maintenance Cleaning your PaperJet 60E Changing the cartridge Page To clean the cartridge and nozzles HEAD MAINTENANCE NEW HEAD: ON NEW HEAD: OFF CLEANING: ON Page Page Technical information Page Index A B C D E I L M N O P R T V Offices worldwide PaperJet 60e_se 6-06-2003 16:52 Pagina 64