BT Response Phone, 125 manual When you have

To record your outgoing message, speak clearly, 15 to 20 cm from the built-in microphone.

Built-in microphone

Read all the steps before you begin recording.

1 Press and hold down

the stop button.

Your Response 125

will beep and the

message indicator

flashes.

2 Keep holding down

the STOP button and

speak your message

into the microphone.

Located on the right-

hand side of the

base near the end

of the handset.

Your Response 125 will automatically play back your message, then beep to confirm the recording. It then returns to ‘answer on’ mode.

To re-record your outgoing message, repeat these steps.

To check your

outgoing message

Press and release the STOP button

Your Response 125 will beep and play back your outgoing message. It will then beep again and return to ‘answer on’ mode.

To delete your

outgoing message

1Press and release the STOP button. Your outgoing message will be played back to you.

2While the message is playing, press the DELETE button.

Your Response 125 will beep and play its pre-recorded outgoing message.

Hello, your call cannot

be taken at the moment, so please leave your message after the tone.

Your own message has now been replaced by the original, pre-recorded message.

To check the day and

time setting

When you have

finished speaking,

release the STOP

button.

You can delete your

outgoing message and	Press and release the
	DELETE button.
reinstate the pre-
recorded outgoing
message.	The currently set day
	and time is announced.

12