8796 Baby Monitor 100 UG [Vtech 2] 27/5/08 13:02 Page 5 BT Baby Monitor 100 VTECH – Issue 2 – 27.05.08 – 8796
Setting up | 5 | |
|
|
|
Parent unit
1.Plug the mains power cable into the socket marked 
on the back of the Parent unit charger.
Connect the other end to the mains power and switch on.
2.Remove the battery compartment cover and insert the 2 x AA rechargeable batteries into the battery compartment on the Parent unit and replace the battery compartment cover as shown. You should always ensure you have inserted batteries in the Parent unit.
3.Slot the Parent unit into the charger, the red charging light comes on. Charge the batteries for 16 hours before switching on the Parent unit.
IMPORTANT
Your BT Baby Monitor 100 is designed to be an aid and should not be used as a substitute for responsible and proper adult supervision.
Make sure the Baby unit, Parent unit and mains adapter cable are kept out of reach of your baby – at least one metre away.
Never place the Baby unit inside your baby’s cot, bed or playpen.
Never cover your Parent or Baby units (e.g. with clothes, towels or blankets).
Never use or place your Parent or Baby units in moist places or near water.
If travelling abroad, make sure that the voltage shown on the mains power adapter corresponds to the local mains power before connecting to the power supply.
There is a risk of explosion if the batteries are replaced by an incorrect type. Dispose of used batteries according to the instructions.
Always dispose of batteries in accordance with applicable waste disposal regulations, never in your household rubbish.
Battery performance - Parent unit Rechargeable batteries in the Parent unit give up to 14 hours continuous performance.
Please note however, that new batteries do not reach full capacity until they have been in normal use for several days.
If you experience any problems, please call the Helpline on 0808 100 6554*
