BT VTECH manual Check the connection, Battery performance Baby unit, Battery low warning Baby unit

8796 Baby Monitor 100 UG [Vtech 2] 27/5/08 13:02 Page 7

BT Baby Monitor 100 VTECH – Issue 2 – 27.05.08 – 8796

	Setting up	7
3. Replace the battery cover, turning the battery lock into the	WARNING!
vertical position again to lock it.	Use only the mains power adapter
	supplied. Using an incorrect adapter
	may permanently damage your BT
Check the connection	Baby Monitor 100.
	The Baby unit will only work from the
When both Units are switched on, the green link lights on both	batteries if the mains power is off or
	disconnected.
Units will come on.	Battery performance – Baby unit
If the link between the Units is broken at any time, the link	The recommended batteries are 4 x AA
	alkaline. Not included.
lights will turn red and flash slowly.
	With new batteries, your Baby unit will
At the Parent unit, you will also hear an alert signal (3 beeps	give up to 14 hours continuous
	performance with the night lights
every 30 seconds) to warn you that there is no communication
	switched off. This will be less if the
between the Units. If this happens, check that the mains	lights are switched on.
power is plugged in and switched on at the Baby Unit.	When the Baby unit is not being used
Also check that the units are within range of one another.	and is disconnected from the mains
	power, you should ensure you remove
	the batteries. This will prevent the
During continual use the Baby unit and Parent unit charger	batteries discharging.
power adapters may become warm to the touch. This is	Battery low warning – Baby unit
normal and not something to be concerned about.
	When the batteries are low –
In the event of power failure, when the power is restored all	approximately within 30 minutes of
	running out – the Baby unit light
your settings will remain unchanged.	will come on. However, this
	will depend on the type of
	batteries used.

If you experience any problems, please call the Helpline on 0808 100 6554*