ASSEMBLY Do not plug this unit into a power source until assembly is complete.
To assemble the stand and motor, review the components diagram as shown in Figure 1 and the Parts List
on page 12. You may choose to begin assembling the stand first and gradually add all other components.
The motor housing may be attached last. Once assembled, attach the Rubber Feet to the four corners of the
stand. The feet will help reduce vibration when the saw is in use. NOTE: When installing the Motor
Support Plate (Part # 82), it must angle toward the front, otherwise the motor will not line up properly
with the Drive Wheel in the upper housing. Ignore the holes on top of Part # 95, as they serve no
purpose. Once the stand and motor are assembled, attach it to the main body of the saw using three long
bolts, through the three elliptical openings (A) in the Upper Cover (Part # 78).
A
Back
Front
Bottom
Top
Figure 1
Figure 2
A
B
C
Once the base is assembled, attach the Drive Belt (Part # 55) to the motor
wheel (A) and to the Spindle Wheel (B) in the compartment directly above.
If the two wheels don’t line up properly, loosen the four bolts (C) holding the
motor in place and slide the motor up or down, depending on need. Once
the wheels line up, retighten the bolts. (Figure 2)
MBSAW Meat Cutting Band Saw w/Meat Grinder Assembly & Operating Instructions 6