Buffalo Tools IW12BX Assembling the Power Switch, Attaching the Stainless Steel Table

Assembling the Power Switch

Do not use sharp tools when assembling the power switch, as they may damage the insulation on the wires.

If you are unfamiliar with electrical work, contact a professional electrician to perform the install.

The ON/OFF power switch (W) is located in the upper corner of the stand. Attach the switch to the side of the steel stand using two nuts, bolts and washers (X). NOTE: Be sure ON is at the top. (Figure 12)

Take the single black power cord and insert the black, white and green wires through the three parts of the cable bushing (Y) before inserting them through the front panel of the stand. (Figure 13) Do not tighten the bushing until the wires are connected to the proper terminals. Once the wires are inserted through the front panel, insert them through one of the holes in the switch cover. (The cover has been removed in Figure 13 to better show the connections to the terminals.) Be sure the clear plastic insulation stays with each wire. Once the wires are through, pull some of the black cable through as well. This will make it easier to connect the wires to the terminals.

Insert the black, white and green wires coming off the motor into the other hole in the switch cover.

Attach the black wires to the terminals on one side of the switch, and the white wires to the terminals on the other side. The green Ground wires are connected directly to the steel side panel with a nut, bolt and washer on each. The Ground symbol is located in the center of two holes, which are covered by stickers.

Remove the stickers, insert a bolt with the ground wire attached through each, and apply the washer and nut. Once tightened, the Ground wires use the steel structure of the machine to ground the electric. (Figure 13)

Attach the switch cover (Z) to the steel cabinet with nuts, bolts and washers, and tighten the cable bushing (AA) by hand. (Figure 14)

Attaching the Stainless Steel Table

Use caution when guiding the table past the saw blade as serious may occur. Wear protective gloves.

W

X

Front of saw t

Figure 12

Y

Ground

Wires

Figure 13

Z

AA

Figure 14

BB

Figure 15

Remove the four socket screws from the table support as described on Page 7 (Figure 3). Then, from the left front side of the machine, hold the table in both hands and guide it up onto the two table guide wheels (BB) on that side. The wheels should fit the rails which are already attached to the underside of the table. Guide the table across the top of the machine to the guide wheels on the opposite side. Once the table is in place, reattach the table support. (Figure 15)

MBSAW Meat Cutting Band Saw w/Meat Grinder Assembly & Operating Instructions 9