PS07401 7-Inch Polisher / Sander Assembly & Operating Instructions 10
INSTALLING THE RUBBER PAD
Improper installation of the rubber pad can cause damage to the rubber pad and the work surface.
The Polisher / Sander is sold with 1 Foam Pad And 1 Wool
Polishing Bonnet and includes a wrench for installation.
Check to be sure the Polisher / Sander is unplugged.
Install the rubber pad by turning the Polisher / Sander upside-down
so the spindle faces up. Press the spindle locking button located on
the top of the Polisher / Sander (Figure 2). Place the rubber pad on
the spindle with the depressed section facing down (Figure 3).
Next, place the clamp washer on the spindle and tighten with the
wrench. (Figures 4 and 5). When installing the Foam pad, follow
Figure 6 & 7, to apply to hook and loop fastener.
INSTALLING THE POLISHING BONNET
Improper installation of the polishing bonnet can cause damage to the polishing bonnet and the work surface.
Make sure the Polisher / Sander is unplugged before installing the
Polishing Bonnet.
For best results, place the Polisher / Sander on a flat, sturdy
surface. Make sure the string on the bonnet is loose and unknotted
before proceeding. (Figure 8) Slip the bonnet evenly around the
rubber pad, and then tie the strings tightly. Secure the loose ends
by tucking them under the edge of the bonnet before using the
Polisher / Sander (Figure 9)
Figure 2
Figure 4
Figure 5
Figure 3
Figure 8
Figure 9
Figure 6
Figure 7