Manuals / Bunn / Kitchen Appliance / Coffee Grinder

Bunn manual IMIX-14, Installation & Operating Guide, Bunn-O-Matic Corporation

Models: 14

1 17

Download 17 pages 3.34 Kb

Page 1

Image 1

IMIX®-14

INSTALLATION & OPERATING GUIDE

BUNN-O-MATIC CORPORATION

POST OFFICE BOX 3227

SPRINGFIELD, ILLINOIS 62708-3227

PHONE: (217) 529-6601 FAX: (217) 529-6644

To ensure you have the latest revision of the Operating Manual, or to view the Illustrated Parts Catalog, Programming Manual, or Service Manual, please visit the Bunn-O-Matic website, at www.bunn.com. This is absolutely FREE, and the quickest way to obtain the latest catalog and

manual updates. For Technical Service, contact Bunn-O-Matic Corporation at 1-800-286-6070.

Page 1

Image 1

Bunn manual IMIX-14, Installation & Operating Guide, Bunn-O-Matic Corporation

Contents

IMIX-14 INSTALLATION & OPERATING GUIDEBUNN-O-MATIC CORPORATION 45304.0001A 09/11 2011 Bunn-O-Matic CorporationBUNN-O-MATIC COMMERCIAL PRODUCT WARRANTY USER NOTICES INTRODUCTIONREAD THE ENTIRE OPERATING MANUAL BEFORE USING THIS PRODUCT INITIAL SET-UP DOOR COVER INSTALLATIONRemove 6. Connect three pin connector to rear of the dis- play DOOR COVER INSTALLATION Continued7. Connect six pin connector to the rear of lower circuit board 8. Replace inner access panel and screws removed in stepELECTRICAL HOOK-UP ELECTRICAL REQUIREMENTSCE REQUIREMENTS Refer to the dispenser’s dataplate for exact voltage requirementsPLUMBING HOOK-UP PLUMBING REQUIREMENTSINITIAL FILL & HEAT RINSE TIMERLIQUID LEVEL CONTROL LOW POWDER LOCKOUTPREVENTIVE MAINTENANCE POWDER PRODUCT STRENGH ADJUSTMENTTouchscreen special cleaning instructions DRAINING THE HOT WATER TANKin any mild, non-abrasive, liquid . Do NOT clean this equipment CLEANINGThe use of a damp cloth rinsed faces on Bunn-O-Matic equipment 1 x 24h2. NORMAL/PROGRAM/RINSE switch 1. ON/OFF/NIGHT switchPROGRAMMING THE DISPENSER IMPORTANT PROGRAMMING NOTES - READ CAREFULLYPROGRAMMING THE DISPENSER Cont BEVERAGES PROGRAMMING SWITCHESto next menu B. Increment display value positivePROGRAMMING THE DISPENSER Cont GLOSSARY READY TEMP ### Adjust minimum tank - EXIT + ready temperature for PROGRAMMING THE DISPENSER ContAdjust tank AUDIBLE ALARM ? NO EXIT YESReturn to B PROGRAMMING THE DISPENSER ContTEST SWITCHES Use Switch To Test RINSE ALARM TIMEPROGRAMMING THE DISPENSER Cont Return to DSINGLE PHASE, 60 HZ SCHEMATIC WIRING DIAGRAM IMIX-142 WIRE + GND 3 WIRE + GND

IMIX®-14

INSTALLATION & OPERATING GUIDE

BUNN-O-MATIC CORPORATION

45304.0001A 09/11 ©2011 Bunn-O-Matic Corporation