16.Do not scratch this surface when cleaning. Deep scratches could cause leakage around the seal.
17.Remove the Drip Tray and Cover.
18.Place all parts in a clean sink with mild hot water (120°F) and sanitizer solution. Allow parts to soak for at least 5 minutes. Carefully wash all components with a clean wash cloth in the hot water and sanitizer solution. Use a clean, soft bristle brush as needed for the smaller components and tight areas. Do not immerse hopper lids. Use a commercial sanitizer that has 100 ppm of available chlorine with a concen- tration level of at least 3% available chlorine
19.Wash the Drum, Hopper Drip Trays, Top Covers, and outer enclosure using a clean wash cloth that has been dampened in the hot water and sanitizer solution. Pat particular attention to the shaft area and make sure it is thoroughly cleaned and sanitized.
20.Thoroughly rinse all surfaces with a clean wash cloth that has been dampened with hot water. Wipe dry with a clean dry wash cloth before reassembling the dispenser.
NOTE: Although most parts are dishwasher safe, they may be affected by the chemicals in some commercial sanitizing agents. Do not place the Hopper or Hopper Lids in a dishwasher. Rinse thoroughly before reassembly.
21.Replace the Auger Nose Bushing inside the front of the Hopper.
22.Install the Hopper Seal over the flange at the rear of the Cooling Drum as shown.
23.Align the Auger Shafts with the Augers. Push the Augers as far as they will go and rotate them so the flat face of the Auger Shaft is aligned with the flat face of the Auger nose.
24.Install the Hopper over the Auger and Cool- ing Drum and slide it into place.
25.Push down until the Hopper Lock Plunger snaps into place.
35113 111302
