DRAINING THE BREWER
The water in your Bunn® Coffee Brewer should be emptied whenever it is taken on a trip, shipped, or stored in an unheated location with a chance of freezing.
1)Unplug the brewer and cool the hot water in the tank. Place the empty decanter on the warmer. Simply pour a full water pitcher of cold water into the top of the brewer, close the lid and wait for the water to stop flowing from the funnel. Empty the decanter, repeat. This will cool the water in the tank.
2)Remove sprayhead by turning counterclockwise with your fingertips and set it aside.
3)Grasp the back of the brewer and quickly turn it upside down over a sink as shown. Most of the water in the tank will flow from the sprayhead opening but some water may flow from the area around the top lid. Continue tipping the brewer until the flow of water ceases.
4)Reinstall the sprayhead when all water has drained from the brewer. Securely tighten it by turning clockwise.
P2084 |
P2082 |
NOTE: Refer to “PREPARING THE BREWER FOR USE” before us- ing the brewer.
HIGH ALTITUDE USE
Your Bunn®
AUTHORIZED SERVICE
For service (whether or not warranty is still in effect), drain the brewer, carefully pack it so it is fully protected against breakage and send it to one of the authorized
Retail Products Division | Retail Products Division |
1400 Stevenson Drive | 16431 Carmenita Road |
Springfield, Illinois 62703 | Cerritos, California 90701 |
(800) | (800) |
13 | 43422.1 010311 |
|