TROUBLESHOOTING (cont.) |
|
|
PROBLEM | PROBABLE CAUSE | REMEDY |
Product will not dispense (cont.) | 6. Main ON/OFF switch | Refer to Service - Main ON/OFF |
|
| Switch for testing procedure. See |
|
| page 12 |
| 7. Probe box LOW/OFF/HIGH | Refer to Service - Probe system. See |
| switches | page 13 |
| 8. Circuit board | Refer to Service - Circuit Board for |
|
| testing procedures. See page 10 |
| 9. Vacuum switch | Refer to Service - Vacuum switch for |
|
| testing procedures. See page 21 |
| 10. Vacuum/Supply pump | Refer to Service - Vacuum/Supply |
|
| pump for testing procedures. See |
|
| page 19 |
| 11. Pump (flavor) start switches | Refer to Service - Pump (flavor) start |
|
| switches for test procedures. See |
|
| page 14 |
Incorrect mix ratio | 1. No water | Water lines and valves to the dis- |
|
| penser must be open. |
| 2. Needle valve | Refer to Setup - Mix Ratio Adjust- |
|
| ments for adjustment. See page 4 |
| 3. Solenoids | Refer to Service - Solenoids for test |
|
| procedures. See page 16 |
Motor thermal cutout (motor stops | 1. Motor overheat | The thermal switch will reset, but |
running) |
| requires up to 30 minutes of cooling |
|
| time. See NOTE below |
NOTE: This refill unit should not be used to initially fill the hopper. Running the motor for extended periods will trip the thermal switch. The thermal switch will reset, but requires up to 30 minutes of cooling time.
8 | 28791 040501 |
|
