TROUBLESHOOTING (cont.)

 

HEATING CIRCUIT (cont.)

 

PROBLEM

 

PROBABLE CAUSE

Water does not heat to proper tem-

6. Tank Heater

perature (cont.)

 

IMPORTANT: Make sure no tem-

 

perature tests are taken before the

 

ready light is "ON". Tank tempera-

 

ture must be stabilized before read-

 

ings are taken.

 

REMEDY

Disconnect the brewer from the power source. Check for continuity between the white terminal of the terminal block (or red terminal on 208/240volt models) and the black wire on the relay on the control board (Toggle Switch must be in 120/208-240V position on 208V & 240V models). There should be a low OHM reading. If no continuity is present, check for a wiring prob- lem, then replace the tank heater if no wiring problem is found. (See page 26)

Page 14

29707.1 082803