BUNN Espress™
INSTALLATION
Model ES•1A™
Placement and installation
Once the machine has been unpacked, it should be placed on a table or counter having sufficient space for easy access to water, electricity and drainage per the following specifications.
•A water inlet pipe.
•An electric plug with ground wire.
•A drain pipe with minimum interior diameter of 35 mm.
2
| 4 |
|
| 1 |
|
| 3 | |
|
| |
1 | .... |
|
2 | .... Pipe with a minimum internal diameter of 35mm (braided hose is provided). |
|
3 | .... Water conditioner 3⁄8" flare |
|
4 | .... Strainer assembly (part # 24744.0000) |
|
Water installation
Pipes for water and drainage connections are located in the lower front part of the machine. To reach them, raise the work and drainage trays. Connect the corresponding pipes, which are packed with the machine in the following way:
From the electric pump to the water conditioner, and from the conditioner to the tap inlet. In the event a water purifier is not installed, the connection from the electric pump should be made directly to the tap outlet. One end of the flexible drain pipe must be connected to the drainage cup section and the other end to the general drain.
NOTE: For cart applications, unit will function with pump suction line suspended into a container of water. Be sure not to run the container dry, damage to the pump will occur.
Electrical installation
Be certain that the available voltage at the installation site is the same as that on the manufacturer’s data plate. This plaque is located on the left side of the machine. The electrical connection should be made directly to a wall socket equipped with a ground wire using the plug provided.
10
