Bunn ES2C service manual Filter Holder Cleaning, Exterior Cleaning, BUNN Espress

BUNN Espress ®

CLEANING

ES•2C™

FILTER HOLDER CLEANING

Bunn-O-Matic recommends daily cleaning for your espresso brewer using the following steps:

1.Place the one-cup basket into the filter holder.

2.Put a teaspoon of any granular espresso cleaner or automatic dish washing detergent (such as Cascade®) into the basket.

3.Lock the filter holder into the right group head. As if you were brewing espresso.

4.Press the right continuous flow button to begin the cleaning process. After about 20 seconds, press the button again to stop the flow of water.

5.Repeat step 4, six times. Decreasing the time to about ten-seconds for each cleaning process.

6.Remove the filter holder from the right group head.

7.Rinse the right group head thoroughly by repeating step 4 a few times without a filter holder installed.

8.Repeat steps 2 through 7 using the left group head.

9.Remove the basket and filter support wire from the filter holder.

10.Use a damp cloth rinsed in any mild, non-abrasive liquid detergent to wipe the inside and outside surfaces of the filter holder, basket, and support wire.

11.Rinse all parts in hot water and reassemble the filter holder.

NOTE: Your hands must be clean before reassembling the filter holder.

12.Repeat steps 2 through 11 with the two-cup filter basket.

EXTERIOR CLEANING

The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all surfaces on Bunn-O-Matic equipment.

10