INITIAL FILL (Continued)
7.Turn ON the refrigeration switch near the main control board. This will start the water bath pump circulation.
8.Check water level in the overflow tube and top off the tank if necessary (Step 5).
9.Disconnect the fill tube and allow excess water to drain into the drip tray. Replace the plug in the end of the fill tube and store back into the dispenser.
10.Set the Program Switch (near main control board) to the OFF position. (On older models without program switch, set the Dispense Lockout Switch to the ON position)
11.Replace the splash panel and drip tray.
12.It will take several hours to create the ice bank required for full dispenser performance. During this time, some further trickling from the water bath is expected due to expansion caused by ice bank formation. While the refrigeration system is creating the ice bank, the dispenser may be readied for use as described in Loading, Priming and Adjustment.
P3582 | P3842 |
FIG 5 Initial Fill Connection - | FIG 6 Initial Fill Connection - |
LOADING
Frozen Concentrates
1.Thaw the frozen concentrate in a refrigerated
2.Thoroughly mix the thawed concentrate by vigorously shaking the product container.
3.Open the dispenser door.
4.Prior to placing the product container in the dispenser, make sure that the
5.Place the product container in the desired position and press it firmly into the bottle adapter opening.
6.Open the vent hole in the product container.
Note: Concentrate in the container must be completely thawed and be within the temperature range of
Ambient Concentrates (Optional)
1.Install an Ambient Concentrate Conversion Kit
2.Attach the concentrate product hose to the appropriate concentrate line located at the rear of the dispenser.
3.Attach the other end of the product hose to the product container through an appropriate fitting.
7 | 44744 032811 |
|
