INITIAL FILL & HEAT
1.Select Normal on the Function Selector Switch and Run on the Mode Selector Switch.
2.Confirm the water supply is on.
3.Connect the dispenser to the power source. The Red POWER LED will illuminate and water will begin flowing into the tank. The dispenser will automatically stop filling when the tank is full. The dispenser will not begin heating the water until after the tank is filled. Dispenser models with product chillers will begin to cool the cabinet at this time.
4.The Green READY LED will illuminate when the tank temperature reaches the preset ready temperature.
Note: The time required to heat the water initially will vary depending on the AC Power supplied to the dispenser.
While the tank is heating, the dispenser may be readied for use as described in Programming Functions & Basic
1 | 1 |
3
4
34766 112502
