Bunn LCC-2 MENU SCREEN RINSE TIME ? -12 Hrs +, Rinse Lockout ? No Exit Yes, Action, Description

MENU SCREEN

RINSE TIME ? (-) 12 Hrs (+)

RINSE LOCKOUT ?

NO EXIT YES

BIB EMPTY LOCKOUT NO EXIT YES

BREW LOCKOUT ?

NO EXIT YES

DLY REPEAT DISP (-) 0 SEC (+)

ACTION	DESCRIPTION
Use the (+) or (-) buttons to	Enter the desired time between required Rinse
adjust Rinse Alarm delay	Cycles in hours, [8 - 24 hrs.]
Select (YES) to enable	Select YES to Lockout dispensing until the Rinse
	Alarm has been cleared. Default is NO
Select (YES) to enable	Select YES to Lockout dispensing until the
	Concentrate BIB has been replaced. Default is
	NO
Select (YES) to enable	Select YES to Lockout dispensing until the hot
	water tank is at READY Temp. Default is NO
Use the (+) or (-) buttons to	Enter the desired time delay before allowing the
adjust the Delay Time	next dispense to take place, [0 - 10 sec.]

The following functions are for diagnostic and troubleshooting purposes and typically do not have to be adjusted. Contact your local service agent for assistance before making changes to these functions.

CAL LEFT SIDE ? EXIT YES

Select (YES) to enable	Selecting Yes will enable the Left Dispenser
	Calibration routine, (see Field Calibration before
	attempting to calibrate the dispenser).

If NO - go to CAL RIGHT SIDE menu.

CAL LEFT PUMP ?

PULL DISPENSE

CAL LF PUMP VOL (-) 43mL (+)

CAL LF WTR FLOW ?

PULL DISPENSER

CAL LF WTR VOL (-) 36.0OZ (+)

CAL LEFT SIDE ? EXIT YES

Place a 50 mL (#34843.1000) graduated cylinder under the Left dispense tip, then activate the Left Dispenser

Use the (+) or (-) buttons to enter volume collected

Place a 64 Oz. (2000 mL) container under the Left dispense tip, then activate the Left Dispenser

Use the (+) or (-) buttons to enter volume collected

NONE

The Left Pump will dispense concentrate for 20 seconds, then shut off automatically. Collect and measure the concentrate dispensed.

Enter the volume of concentrate measured from the Left Pump in mL, (not Oz.) regardless of Preferred Units selected.

The Left Dispenser will dispense hot water for 20 seconds, then shut off automatically. Collect and measure the water dispensed.

Enter the volume of the water measured from the Left dispenser in Oz. (mL).

Scroll down to bypass this screen.

CAL RIGHT SIDE ? EXIT YES

Select (YES) to enable Selecting Yes will enable the Right Dispenser

Calibration routine. Calibration routine, (see Pump Calibration) prior to calibrating the dispenser.

15 34766 120105