Bunn MCPA manual Troubleshooting, Situation, Explanation

TROUBLESHOOTING

SITUATION

Nothing happens when the COFFEE BUTTON or TEA BUTTON is pressed.

EXPLANATION

This is the first time you have used your brewer.

The Initial Brewer Set-up procedure must be performed first. Please follow the directions on page 9 before attempting to run a brew cycle.

Your brewer is not plugged in.

Check to make sure the brewer is plugged in and the POWER SWITCH has been turned on. (The POD HOLDER RELEASE BUTTON

-also known as the BUNN Indicator - will be illuminating red, indicating power to the brewer.)

The HEATING INDICATOR is lit.

Wait until the indicator goes off before pressing one of the brew buttons. The brewer will not start a brew cycle until the water in the internal tank is heated to the proper temperature.

The POD HOLDER INDICATOR is lit.

Check to make sure the POD HOLDER is inserted into the brewer.

If the POD HOLDER is inserted into the brewer, carefully remove and replace the POD HOLDER to ensure the POD HOLDER is locked in place.

Listen for a clicking sound. The click indicates that the holder has locked into place.

The REFILL WATER INDICATOR is lit.

The reservoir has run low on water and needs to be filled above the minimum mark indicated on the side of the reservoir.

15