Bunn MCPA manual Initial Brewer Set-Up

INITIAL BREWER SET-UP

1. Remove the lid and water reservoir.

P3017

(CAUTION: Do not place the brewer in a sink or other water source.)

2.Thoroughly rinse the water reservoir.

3.Fill the reservoir to the maximum line with

fresh cold water.

P2901

4. Replace the reservoir and li

and close the slide lid.

P2902

5. To ensure the Pod Holder
is locked in place, use
thumb to press the pod
holder release button to
eject the holder and then
press all the way in to
lock.	P2908

(CAUTION: You should hear a clicking sound when the pod holder locks in place.)

7. Plug in the brewer and turn on the power switch.

P0214/2905

8.	Place a mug or bowl that
	will hold at least 414 ml (14
	fl. oz.) onto the drip tray
	grate.	P2904
9.	Press and release
	the coffee brew
	button to fill the

internal	water
tank.*	P2907

(CAUTION: Water may not immediately flow from the brewer. Never remove pod holder from brewer during a brew cycle.)

10.Empty any water in the mug or bowl and place the mug back on the drip tray grate.

(NOTE: Wait for Heating Indicator to go out before proceeding to Step #11)

11. Press and release the coffee brew button a second time.*

P2907

(CAUTION: Water should flow from the pod holder. Wait until water drip out has finished before removing the pod holder.)

6. Slide the volume control lever to the maximum setting.

P2952

You are now finished preparing the brewer for it’s first use. Proceed to the “Brewing Delicious Coffee Or Tea” section.

* Some noise is normal when the water pump is running.

9