RECOMMENDED DAILY CLEANING (ULTRA-2 shown)
NOTE – Turn the power OFF to the dispenser before proceeding.
1.Empty all product from the hopper(s). Disconnect the hopper lid lamp cord(s) and remove the lids.
2. Depress the hopper lock plung- 3. Pull forward to remove. | 4. Pull the auger from the cooling |
er. Lift the hopper up slightly. | drum. |
5. Remove the cooling drum seal 6. | Caution: The faucet valve is 7. | Carefully slide the faucet valve |
from the rear of the drum. | under spring tension. Spread | up to remove the spring and |
| one side of the handle first, then | faucet seal. Extra care should |
| the other and disconnect from | be taken when handling the |
| the hopper. | seal to prevent damage. Do not |
|
| fold the seal as this will cause |
|
| damage to the Teflon® sealing |
|
| surface. |
9. Care must be taken to ensure this surface does not get scratched dur- ing cleaning. Deep scratches could cause leakage around the seal.
10.Place all parts in a clean sink with mild hot water (120°F) and sanitizer solution. Allow all parts to soak for at least 5 minutes. Carefully wash all components with a clean wash cloth in the hot water and sanitizer solu- tion. Use a clean, soft bristle brush as needed for the smaller components and tight areas. Do not immerse hopper lids. Use a commercial sanitizer that has 100 ppm of available chlorine with a concentration level of at least 3% available chlorine
11.Wash the drums, hopper drip trays, top covers, and outer enclosure using a clean wash cloth that has been dampened in the hot water and sanitizer solution. Pay particular attention to the shaft area and make sure it is thoroughly cleaned and sanitized.
12.Thoroughly rinse all surfaces with a clean wash cloth that has been dampened with hot water. Wipe dry with a clean dry wash cloth before reassembling the dispenser.
NOTE – Although most parts are dishwasher safe, they may be affected by the chemicals in some commercial sanitizing agents. Do not place the hopper nor hopper lids in a dishwasher. Rinse thoroughly before assembly.
8 | 41084 102709 |
|