On the right side, remove the old catch from the frame saving the Phillips head bolt. Install the new catch using the existing Phillips head bolt and new standard nut provided. Tighten securely.
Replace the roll bar into the new hinge. Use the
1.5inch hex bolt from the old hinge and the new jam locking nut provided. Tighten until the end of the bolt is flush or slightly protrudes beyond the nut.
1
2
(This can be done with the No. 2 Phillips driver.) the hole from growing
Locate the pair of handle receiver mounting holes on the bottom of both the hinge and catch (See 1 and 2 on diagram to the left).
Carefully punch or cut a hole through the trailer fabric, small enough to allow a bolt to pass through to the mounting holes. The fabric is rip resistant to prevent
Check that the new roll bar catch and hinge parts and the roll bar is properly installed. Check the attachment points for loose elements. Failure to do so could result in serious injury.
5
