ASSEMBLY
6.Remove linch pins and 1” hitch pins from loader upright.
7.Start tractor engine and release brakes. Retract bucket cylinders to allow parking stands to contact ground.
8.Extend lift cylinders 6” to 8” to rotate top of loader uprights forward out of the mount, allowing tractor to be pushed rearward. Retract bucket cylinders until lower loader upright pins clear mount pin saddles and front tires (See Figure
9.Move tractor rearward approximately 6”, being certain not to stretch hydraulic hoses.
10.Stop tractor engine and set parking brake. Relax lift cylinders and bucket cylinders by moving each control lever in both directions. Disconnect hydraulic hoses from tractor.
11.Start tractor engine and release brakes. Slowly back tractor out of loader.
1145 01/11 | Assembly Section |
© 2011 Alamo Group Inc.
ASSEMBLY
