Figure 3 Safety Locks
Swing Lock Pin |
| Boom Transport Lock Pin |
|
|
|
SWING LEFT AND RAISE the boom by moving the control lever back and to the left.
SWING RIGHT AND LOWER the boom by moving the lever forward and to the right.
SWING RIGHT AND RAISE the boom by moving the lever back and to the right.
3.Crowd/Bucket: Push lever forward, the dipperstick moves out, away from the operator. Pull lever back, the dipperstick moves in, toward the operator.
Move lever to left, the bucket curls in. Move lever to right, the bucket extends out.
By moving the lever to one of the intermediate posi- tions, the dipperstick can be extended or retracted at the same time the bucket is being loaded or dumped.
EXTEND AND LOAD the bucket by moving the lever forward and to the left.
RETRACT AND LOAD the bucket by moving the lever back and to the left.
EXTEND AND DUMP the bucket by moving the lever forward and to the right.
RETRACT AND DUMP the bucket by moving the lever back and to the right.
The two operations of the boom/swing lever, com- bined with the two operations performed by the crowd/bucket control lever, provide four simultaneous operations from the two levers, keeping cycle time to a minimum.
4.Right Hand Stabilizer: Push lever forward, the RH stabilizer lowers. Pull lever back, the RH stabilizer raises.
Figure 3a
Lock Pins
Storage Tubes
In general, the direction of movement of a control lever corresponds to the movement of the operating member.
OPERATING THE BACKHOE
CAUTION 
To avoid possible injury, observe the following safety rules WHEN OPERATING the backhoe.
1.DISENGAGE safety lock pins as shown in Figure 3 before attempting to operate the back- hoe. Store lock pins in angled tubes located at the rear right hand side of the backhoe below the foot platform. See Figure 3a.
2.OPERATE from the backhoe operator’s seat only.
3.LOWER the stabilizers until the rear of the trac- tor is totally supported by them. NOTE: Rear tires should not come up off of the ground. See dia- gram on Page 11.
4.DO NOT dig near the stabilizers.
5.DO NOT touch overhead wires with any part of the backhoe.
6.DO NOT attempt to raise the tractor off the ground or move the tractor forward or backward using the backhoe dipperstick or bucket.
7.DO NOT lose stability by swinging the bucket downhill when positioned on a slope.
8.DO NOT lower the backhoe boom using the “float” function. It will freefall, and could result in injury to bystanders or damage to the backhoe.
9
