Bush Hog 305, 306 manual Contact authorized Bush Hog dealer Minimum Overlap

Figure 2-3

H. Hold driveline sections parallel to each other and check for minimum 6 inches (15cm) overlap. Figure 2-4). If driveline has been marked for cutting, overlap will be the distance between two marks. If driveline has less than minimum overlap, do not use.

Contact authorized Bush Hog dealer.

Figure 2-4

Minimum Overlap

NOTE

If driveline is the correct length, omit the following steps “I” through “L” and proceed to step “M”.

I. Clamp driveline in a well padded vice to pre- vent damage to the shield. Cut off shield where marked. (Figure 2-5)

Figure 2-5

J. Using cut off section of shield as a guide, cut shaft the same amount. (Figure 2-6)

Figure 2-6

K. Repeat steps “I” and “J” to other driveline section.

L. Deburr ends of driveline sections and clean away all chips and filings. (Figure 2-7)

Figure 2-7

M. Apply multi-purpose grease to inside of outer (female) driveline section. Assemble driveline and install on tractor and cutter. Pull on each driveline section to be sure yokes lock into place. Make certain driveline shielding is in place and in good condition.

N. Adjust lower lift arm(s) to level cutter right to left. Refer to tractor operator's manual for instructions.

NOTE

After attaching driveline to tractor, attach driveline shield chains from both ends of driveline shielding to stationary locations.

8