Bush Hog 3227 QT, 2427 manual Fixed Pivot PIN, Loader Models 2447 QT, 2847 QT

WARNING

USE CAUTION WHEN MOUNTING LOADERS EQUIPPED WITH OPTIONAL CONTROL VALVE ON TRACTORS EQUIPPED WITH CANOPY. RAISING LOADER SUBFRAME TOO HIGH CAN PINCH HAND BETWEEN CONTROL HANDLE AND CANOPY CAUSING INJURY.

D. With tractor at idle speed, carefully activate boom cylinders to raise/lower cross tube until it aligns with front bracket channel.

E. Drive tractor forward until cross tube fully engages front bracket channel and install front bracket pin. (Figure 2-3)

Figure 2-3 Front Bracket Pin

Figure 2-4 Cuff Arrangement

LOADER MODELS: 2427 QT, 3227 QT

Tighten Nut To 100 ft./lbs.

Cuff With Welded-On Bolt

FIXED

PIVOT PIN

LOADER MODELS 2447 QT, 2847 QT

Square Head Bolt

Removable

Pin

Tighten Nut To 100 ft./lbs. Cuff

Figure 2-5 Parking Stand Storage

F. Extend bucket cylinder (dump) until subframe rest on rear bracket.

G. Install cuff per Figure 2-4 as shown for model loader being mounted.

H. Tighten nut retaining cuff to 100 ft./lbs.

I. Raise boom, remove parking stands and slide into loader frame for storage. Retain parking stands with pins during storage. (Figure 2-5)

WARNING

DO NOT STAND UNDER LOADER WHILE

REMOVING/INSTALLING PARKING STANDS.

Fully Insert Stands And Pin Into Place

11