ASSEMBLY (Refer to Figure 21 & 22)
IMPORTANT: Tighten all hardware to the torque requirements specified in the torque chart.
WARNING 
TO PREVENT BODILY INJURY, DO NOT OPERATE BACKHOE UNLESS LOWER LINK WELDMENTS (217,218) ARE PROPER-
LY INSTEALLED AND ADJUSTED. FAILURE TO DO SO MAY RESULT IN BACKHOE BEING THRUST UPWARD, CRUSHING OPERATOR AGAINST CAB OR ROPS.
1.Use hoist to raise the backhoe mainframe so that the boom pivot pin is approximately 16” off the ground.
2.Back tractor close to the backhoe. Connect tractor lower link arms to lower link mounts at position “C”, Figure 22, using two
NOTE: If tractor has a category II hitch, install two bush- ings (215) in lower link arms as shoen in Figure 21.
3.Attach upper braces (221), Figure 21 to backhoe with 3/4 x
4.Install bushing (213) or bushing (216) in the hole of the upper bar (220) that most closely matches the diameter of the tractor upper link pin, as shown in Figure 21. No bushing is necessary for Category II tractors.
5.Secure upper bar (220) between upper braces (221) using 3/4 x 5” bolts (203), flat washers (210), and nuts (207). Use hoist to raise or lower backhoe slightly until a hole in the upperr bar aligns with a hole in the upper braces. See Figure 21.
6.Attach RH lower link weldment (217) and LH lower link weldment (218) to backhoe mainframe using 3/4 x
7.Align RH and LH link weldment (217, 218) with a hole in the upper bar/brace assembly, as close to the tractor as possible. Use 3/4 x
8.Remove backhoe from the tractor.
9.Install connector plate (219) to RH and LH lower link weldments (217, 218) using 5/8 x 2” bolt (200), lockwasher (208), and nut (206). See Figure 21.
10.Tighten all hardware at this time. Check your installation very carefully to be sure all members are correctly installed and securely fastened.
10A. If using optional PTO Pump and Reservoir Kit proceed to that section prior to remounting the back- hoe onto the tractor.
11.Connect hoses from the backhoe control valve to the tractor hydraulic system as described in “Hydraulic
Figure 22 |
|
|
|
|
| Tractor Upper | ||
|
|
|
|
|
|
|
| Link Weldment |
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Upper Brace | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Upper Bar | ||
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Backhoe Mainframe
| Boom Pivot Pin | C | Tractor Lower Link | |
|
|
| ||
|
| Link Weldment |
| |
|
|
| 29 |
|
|
|
|
| |
|
|
|
|
|
