Bushnell 11-1210 manual Turning the Display on and OFF, Taking a Picture

to check the camera aim and focus before taking a new photo. To turn the unit off, press and hold the MODE button until the display goes out and the camera beeps 3 times. The camera will turn itself off automatically to save batteries if it is left inactive for one minute. When connected to a PC for downloading photos, the camera draws power from the USB port.

TURNING THE DISPLAY ON AND OFF

Press the Display button (right side of the large 4-way switch) to turn the display off. Turning the display off when it is not needed will save power and extend the useful life of the batteries. To turn the display back on, press Display again.

TAKING A PICTURE

With the camera turned on, press the SNAP button to take a new photo. For best results, hold the ImageView steady using both hands. Lightly press down the SNAP button using the flat end of your finger, then release it. Avoid “punching” the SNAP button rapidly with a fingertip, resulting in shaky photos. You will hear two quick beeps to confirm a photo was taken, and briefly see a screen displaying the remaining photo capacity (now one less), battery indicator, and resolution setting (1 or 3 stars).

REVIEWING AND DELETING STORED PICTURES

You may review previous images currently stored in the camera’s memory by either scrolling through them one at a time, or seeing a “slide show” which automatically displays and changes images. To see individual images, just press the UP (most recent to oldest photo) or DOWN (oldest photo first) buttons on the 4-way switch. If you see a photo you wish to delete, press SNAP. You will hear a rapid

2

11-1210 1LIM.indd 6 11/17/04 9:31:22 AM