Bushnell 118326 BASIC SETUP

Turn the SyncFocus over, slide open the battery cover as indicated by the arrow, remove and set aside. Insert 2

AAA Alkaline or Lithium batteries into the compartment (G) in the direction indicated inside, then replace the

cover, sliding it back into place until it clicks. Note: Rechargeable NiMh type batteries may also be used, but

some may not deliver adequate current to power the camera and display. AAA NiMh batteries with a current

rating of 850 mAh or higher are recommended.

The camera can store from about 15 (at 2660x1920 resolution and “Best” quality) up to over 100 photos in the

internal memory, depending on resolution and quality settings. To expand the available storage, you may

add an optional SD or SDHC (High Capacity) memory card, with 32GB or lower capacity. The camera will

not function if a 64GB or higher capacity SD card is inserted. Do not use “MMC” cards, which look similar to

SD cards. The card is inserted into the slot (J) on the back of the camera pod (pull down the rubber cover ap-

please refer to the “Camera and Binocular Parts Guide” page), label side up with the “notched” corner on the

right as indicated by the card icon above the slot. Note: be sure the power is turned o before inserting or

removing cards to prevent possible loss of les or damage to the card. A new card will not require formatting,

but a card that has been previously used in other devices (cameras, mp3 players, etc) should be formatted by

the SyncFocus before you start taking photos (see the “Using the Review Menu” section for details). Note that

formatting will erase all les previously stored on the card, so be sure they have been downloaded and

saved on your computer rst if you wish to keep them.

BASIC SETUP