SETTING THE TIME
Default Time Mode / Time Settings
Press MODE button until Time Mode is displayed. Press and hold down ADJ for 3 seconds. Press COMP/+ or BARO/- button until desired value appears, and then press MODE button for next setting. Press ADJ button at any time to save changes and exit. When this is done, seconds will be reset to 00. A small "A" or "P" will be to the lower left of the hours to denote AM or PM.
Date Settings
When setting the date, the year is also displayed. Press MODE button until Time Mode is displayed. Press and hold down ADJ for 3 seconds. Press MODE button and scroll to desired setting to change. Press COMP/+ or BARO/- button until desired value appears, and then press MODE button for next setting. Press ADJ button at any time to save changes and exit.
For 24/12 hour setting press MODE button until Time Mode is displayed. Press and hold down ADJ for 3 seconds. Press MODE button and scroll through settings until 24/12 hour setting appears, then press COMP/+ or BARO/- button to enter desired setting. Press ADJ button at any time to save changes and exit.
New Settings
ALARM
Alarm Setting Mode
Press MODE button until Alarm Mode is displayed. The alarm consists of 5 alarms, 3 for Time 1 for Altitude, and 1 for Temperature. Press COMP/+ or BARO/- button to scroll through the different alarms. Press and hold down ADJ for 3 seconds until the minute blinks, press COMP/+ or BARO/- button to adjust to desired values. Press MODE button for next setting. Press ADJ button at any time to save changes and exit. The alarm is activated automatically after adjustments have been made. To stop the alarm from beeping, PRESS ANY BUTTON.
The alarm can also be turned on or off by going to the relevant alarm and pressing the ALTI button to activate alarm function, press again to activate Snooze function, and press again to
Temperature Alarm
Sets the alarm to sound when the temperature measurement reaches the programmed level. In the Alarm Mode, the Temperature alarm uses the same measurement units (ºC or F) that were last set in the Temperature Mode. To change this you must first change the temperature units in the Barometer Mode. Pressing the COMP/+ or BARO/- once changes the temperature in tenths of a degree. Holding the button down changes the temperature in increments of 1 degree.
4 | 5 |
|
