2 CAUTIONS ON INSTALLATION

Noise or disturbance of the picture may be generated if this unit or any other electronic equipment using microprocessors is used near a tuner or TV.

If this happens, take the following steps:

Install this unit as far as possible from the tuner or TV.

Set the antenna wires from the tuner or TV away from this unit’s power cord and input/output connection cords.

Noise or disturbance tends to occur particularly when using indoor antennas or 300 /ohms feeder wires. We recommend using outdoor antennas and 75 /ohms coaxial cables.

For heat dispersal, leave at least 0.3 ft (10 cm) of space between the top, back and sides of this unit and the wall or other compo- nents.

ENGLISH

0.3 ft (10 cm) or more

B

0.3 ft (10 cm) or more

Wall

3CAUTIONS ON HANDLING

Switching the input function when input jacks are not connected

A clicking noise may be produced if the input function is switched when nothing is connected to the input jacks. If this happens, either turn down the VOLUME control or connect components to the input jacks.

Muting of PRE OUT jacks, HEADPHONE jack and SPEAKER terminals

The PRE OUT jacks, HEADPHONE jack and SPEAKER terminals include a muting circuit. Because of this, the output signals are greatly reduced for several seconds after the power operation switch is turned on.

If the volume is turned up during this time, the output will be very high after the muting circuit stops functioning. Always wait until the muting circuit turns off before adjusting the volume.

Whenever the power operation switch is in the STANDBY state, the apparatus is still connected on some AC line voltages.

Please be sure to unplug the cord when you leave home for, say, a vacation.

Range of operation of the remote control unit

30° 30°

Approx. 23 feet/7 m

Point the remote control unit at the remote control sensor as shown on the diagram at the left.

NOTES:

The remote control unit can be used from a straight distance of approximately 23 feet/7 meters, but this distance will shorten or operation will become difficult if there are obstacles between the remote control unit and the remote control sensor, if the remote control sensor is exposed to direct sunlight or other strong light, or if operated from an angle.

Neon signs or other devices emitting pulse-type noise nearby may result in malfunction, so keep the set as far away from such devices as possible.

4FEATURES

1.Powerful, Versatile Amplifier High-Quality Power Amplifier:

High-speed, high-power transistors employed in a rational circuit configuration reflect DENON’S advanced amplifier technology and ensure a very hefty, clean power output.

2.Signal Level Divided Construction (SLDC)

The circuits handling low-level and high-level signals have been divided into separate blocks to ensure that influences from these signals on each other are held to an absolute minimum. This chassis design in this unit is called the Signal Level Divided Construction (SLDC). Signals for output are cleaner than before, allowing them to be reproduced with even greater fidelity and clarity.

3.Remote Control Functions

The Remote Control (RC-895) commands not only the receiver but can also operate the main functions of a DENON CD player and a cassette deck.

5

Page 5
Image 5
Denon DRA-295 manual Features, Signal Level Divided Construction Sldc, Remote Control Functions, Ft 10 cm or more Wall