OPERATIONAL SUMMARY
While holding the product in your hand at arm-length, turn the unit ON by quickly pressing and releasing the trigger with your index finger. All liquid crystal segments and icons will initially be displayed. The trigger is located underneath the objective lenses and when depressed again for ranging generates an audio beep. Next, look through the red dot sighting system and locate the red dot. The object you intend to acquire distance to can easily be targeted by placing the red dot upon the object.
The PinPro features two targeting modes, PinFire Mode and Non-PinFire Mode. When a target is acquired in PinFire Mode the audio alarm sounds two beeps and distance is displayed on the external LCD. When a target is acquired in Non-PinFire Mode the audio alarm sounds three beeps and the distance is displayed on the external LCD. Once the unit is ON, PinFire Mode is initiated by a quick press and release of the trigger. PinFire Mode should be used when the REFLECTIVE prism is attached to the top of the flag stick. While in this mode, the laser pulses will continue firing for approximately 5 seconds and then stop.
If the trigger is pressed and held the unit will go into Non-PinFire Mode and will hit most anything without a reflective prism to 450 yards. This mode can be activated by pressing the trigger button after 2-3 seconds of PinFire mode. You may either hold the button from the initial press, or press and hold the trigger anytime after the ~2-3 seconds of PinFire Mode (i.e. quick press-release, wait ~2-3s, press and hold). Non-PinFire Mode is maintained as long as the trigger is pressed, a valid reading is obtained, or the timeout expires.
