Cabletron Systems 9E106-06 manual Installing the Epim, Epim Epim Board Revision

Installing the 9E106-06 Module

Table 2-1. EPIM Board Revisions

EPIM	EPIM BOARD REVISION
EPIM-T	04 or greater
EPIM-F2	05 or greater
EPIM-F1	05 or greater
EPIM-F3	02 or greater
EPIM-C	05 or greater
EPIM-A	Not Applicable
EPIM-X	02 or greater

Installing the EPIM

To install an EPIM:

NOTE

When removing an EPIM, make sure to pull the module straight out so as not to damage the connector.

1.Remove the coverplate or the EPIM (whichever applies).

2.Slide your new EPIM into place, making sure the connectors on the rear of the module and inside the HUB attach properly. Refer to Figure 2-3.

3.Install the mounting screw.

2-4