Cabletron Systems 9E106-06 , Setting the Module Card DIP Switch

2-7

Installing the 9E106-06 Module

Figure 2-5. User-Accessible Components

Setting the Module Card DIP Switch

An eight-switch DIP switch is located on the module card, as shown in Figure 2-5

and Figure 2-5. The functions of the switches are listed in Table 2-2.

Flash

SIMM

Socket

Packet

DRAM

Socket

Local

DRAM

Socket

Boot

PROM

Dip

Switch

SMB-1

PROM

Contents

Main Page i Notice Notice ii Notice FCC Notice VCCI Notice Page Page Contents Page Chapter 1 Introduction Features Page Page Related Manuals Getting Help Page Chapter 2 Installing the 9E106-06 Module Page Installing EPIMs EPIM Revisions Installing the EPIM The Reset Switch Page Installing the 9E106-06 Module 2-7 Setting the Module Card DIP Switch Page Installing the 9E106-06 Module 2-9 See the at the end of this table. Cautions Page Chapter 3 Operation Six Front Panel Ports System Management Buses SMB-10 Bus SMB-1 Bus DC/DC Converter FNB Interface i960 Switch i960 Host Page 4-1 Chapter 4 LANVIEW LEDs Page 4-3 LANVIEW LEDs The functions of the Ethernet Receive LEDs are listed in Table 4-1. The functions of the Ethernet Transmit LEDs are listed in Table 4-5. Page Chapter 5 Specications Technical Specications Safety Service Physical Dimensions: Weight: Appendix A EPIMs EPIM-T EPIM-F1 and EPIM-F2 EPIM-F3 EPIM-C Connector Type Grounding EPIM-A and EPIM-X (AUI Port) Table A-4 lists the DB-15 pinouts.