Manuals / Cabletron Systems / Computer Equipment / Network Card

Cabletron Systems 9F120-08 Installing the SmartSwitch 9000 Module, Unpacking the Module, Chapter

Models: 9F125-0 9F122-12 9F120-08

1 36

Download 36 pages 733 b

Page 21

Installing the SmartSwitch 9000 Module

Chapter 2

Installing the SmartSwitch 9000 Module

Only qualified personnel should perform installation procedures.

Unpacking the Module

1.Carefully remove the module from the shipping box. (Save the box and packing materials in the event the module must be reshipped.)

2.Remove the module from the plastic bag. Observe all precautions to prevent damage from Electrostatic Discharge (ESD).

3.Carefully examine the module, checking for damage. If any damage exists, DO NOT install the module. Contact Cabletron Systems immediately.

User Accessible Components

Figure 2-1shows the various components that are accessible to the user. These consist of an eight-position DIP switch, replaceable PROMs and sockets for RAM. These components will be used for future upgrades. Instructions for installing the components will be supplied with the upgrade kit.

2-1

Image 21

Cabletron Systems 9F120-08 manual Installing the SmartSwitch 9000 Module, Unpacking the Module, User Accessible Components

Contents

9033274 SmartSwitch 9E531-24 24 Port 10BASE-FL Ethernet Module User’s GuidePage FCC NOTICE INDUSTRY CANADA NOTICEVCCI NOTICE CABLETRON SYSTEMS, INC PROGRAM LICENSE AGREEMENT CABLETRON SYSTEMS SALES AND SERVICE, INC PROGRAM LICENSE AGREEMENT CABLETRON SYSTEMS LIMITED PROGRAM LICENSE AGREEMENT 4. EXPORT REQUIREMENTS. You understand that Cabletron and its Affiliates are subject to regulation by agencies of the U.S. Government, including the U.S. Department of Commerce, which prohibit export or diversion of certain technical products to certain countries, unless a license to export the product is obtained from the U.S. Government or an exception from obtaining such license may be relied upon by the exporting party READ THE FOLLOWING SAFETY INFORMATION BEFORE SAFETY INFORMATION CLASS 1 LASER TRANSCEIVERSINSTALLING OR OPERATING THESE MODULES SAFETY INFORMATION CLASS 1 LASER TRANSCEIVERSDECLARATION OF CONFORMITY viii Specifications ContentsChapter IntroductionDimensions ContentsWeight EnvironmentFeatures IntroductionChapter Figure 1-1. The 9E531-24 Introduction9E531-24 ETHERNETAll purchased bandwidth is used WebView ManagementRemote Monitoring RMON Broadcast SuppressionThe 9E531-24 supports the following two types of flow control LANVIEW Diagnostic LEDs GARP Switch OperationStandards Compatibility Year 2000 ComplianceRelated Manuals Getting Help User Accessible Components Installing the SmartSwitch 9000 ModuleUnpacking the Module ChapterFigure 2-1. User-Accessible Components Installing the SmartSwitch 9000 ModuleSee the Cautions at the end of this table SwitchFunction DescriptionUsing DIP Switch Installing the Module into the SmartSwitch 9000 Chassis4. Lock down the top and bottom plastic tabs, as shown in Figure The Reset Switch Cabling Requirements10BASE-FL Network SmartSwitch Architecture Technical OverviewChapter System Management Buses Figure 3-1. Block DiagramTechnical Overview DC/DC Converter System Diagnostic ControllerSMB-1 Bus SMB-10 Busi960 Core INB InterfaceChapter LANVIEW LEDsINB Receive System Status INB TransmitLED Color LANVIEW LEDsState DescriptionColor LANVIEW LEDsState LED ColorLANVIEW LEDs Specifications Technical SpecificationsChapter Service Regulatory CompliancePhysical