4-12
Monitoring and Managing Your ELS10-26
LCM displays the current IP address table, for example:
To change the subnet mask, at the LCM prompt:
1. Type ipaddr <PORT-NUMBER> <IP ADDRESS> <SUBNET MASK>
For example, ipaddr 6 192.138.217.40 255.255.240.0 would set
the subnet mask for port 6 to 255.255.240.0. LCM responds by
redisplaying the address table.
To assign a new IP address, refer to Section 3.1.
4.5.4 Changing a Community Name
A community name is similar to a password. You use the same
steps to assign a new community name or to change an existing
community name. This sets the MIB variable sxadminAnyPass. You
can then enter a community name to perform any SNMP sets.
To assign a community name, at the LCM prompt:
1. Type community
2. Enter the old community name.
If one has not been assigned, you do not need to enter
anything. LCM prompts you for the new community name.
Note: When you change the subnet mask for a port, you must also enter
the IP address for that port. Make sure you enter the IP address for
the port correctly; whatever you enter becomes the IP address.
Port IP Address Address Mask MAC Address
1
2
3
4
5
6
7
192.138.217.1
0.0.0.0
192.138.217.10
0.0.0.0
0.0.0.0
192.138.217.20
192.138.217.50
255.255.255.0
255.0.0.0
255.255.255.0
255.0.0.0
255.0.0.0
255.255.255.0
255.255.255.0
00:40:27:00:06:1f
00:40:27:00:06:c3
00:40:27:00:06:3e
00:40:27:00:03:7a
00:40:27:00:05:c7
00:40:27:00:04:4a
00:40:27:00:06:9e