10 | MONO BRIDGING 2 AMPLIFIERS INTO 1 WOOFER |
|
|
MASTER/SLAVE CONNECTION DIAGRAM
Mode switch
IMPORTANT:
Link between 2 amplifier | Ground |
- speaker terminals | |
#14 minimum |
|
BURSTPR
POWER
2 ohm
FULL POWER | minimum |
LEVEL | |
BATTERY | |
VOLTAGE | |
FULL | Pm2 |
| |
Mode switch | Cable |
|
Distribution
block
Master fuse
at battery
Battery
Boom
Harder!
Set the AMPLIFIER MODE switches as shown
Connect the source to the master amplifier inputs, and an optional CPR remote control to the master, as shown.
Use a PM2 bridging cable to connect the master output of the first amplifier to the slave input of the second.
Connect the speaker as shown, with the link between the negative speaker terminals of the two amplifiers.
Connect the ground terminal with as short a piece of cable as possible to the nearest metal chassis point.
Mount a master fuse right at the battery + terminal as shown. Add up the current draw for all amplifiers in the system to determine the rating for this fuse. Use a power distribution block, such as the Cadence
Connect the remote turn on signal from the source to all amplifier remote turn on terminals.