Cadet RM108 Part Two, Installation Instructions, 900W-240V, 700W-240V, 1000W-120V, 500W-120V

STEP 1

Installation Instructions

Part Two

If you are installing a Multi-Watt heater, model numbers RM151 or RM162, begin with STEP 2 below. If you are installing an RM202, RM208, or RM108, begin with STEP 3 below.

STEP 2 Element Wire Configuration (Multi-watt models RM151 or RM162 only)

Cadet’s Multi-Watt RM heater offers a variety of heat output options. You must first determine the desired wattage and then configure the heating element wire connections. The heater is shipped from the factory configured for 1600 Watts (240V) or 1200 Watts (208V) for RM162, and 1500 Watts (120V) for RM151. If this is the wattage you desire, proceed to STEP 3.

On models RM151 and RM162, mark the wiring diagram on the back of the heater with the wattage used for future reference.

FIGURE 1 RM Wiring Table

			YOUR WIRES WILL BE CONFIGURED LIKE THIS:
MODEL	VOLTAGE	IF YOUR DESIRED	Upper Element A		Lower Element C
		WATTAGE IS:	900W-240V		700W-240V
		1600	Yellow Terminal	X	Blue Terminal Z
RM162	240V	900	Yellow Terminal		None (*)
				X
		700	None (*)		Yellow Terminal X
			675W-208V		525W-208V
		1200	Yellow Terminal	X	Blue Terminal Z
RM162	208V
		675	Yellow Terminal	X	None (*)
		528	None (*)		Yellow Terminal X
			1000W-120V		500W-120V
		1500	Yellow Terminal		Blue Terminal Z
RM151	120V			X
		1000	Yellow Terminal X		None (*)
		500	None (*)		Yellow Terminal X

*Cut Blue Terminal from Red Wire and wrap with electrical tape. Yellow Terminal Y remains connected at B . Do Not Touch.

675W-208V

900W-240V

1000W-120V 525W-208V

700W-240V

500W-120V

MANUAL RESET

HIGH TEMP CUTOFF

Motor End View

Heater Element Locations

WARNING Risk of Electrical Shock. Connect grounding lead to grounding wire provided. Keep all foreign objects out of heater.

WARNING Risk of Fire. Heater must be kept clear of all obstructions: a minimum of 3 feet in front; 6 inches on both sides and above. Heaters must be kept clean of lint, dirt and debris.

WARNING Turn the electrical power off at the electrical panel board (circuit breaker or fuse box) and lock or tag the panel board

STEP 3 Install Heater Assembly

Set the heater assembly (blower wheel first) into the left side of the wall can. Fasten at top with screw provided. Unlace heater lead wires. Connect the supply wires to the heater wires (See Figure 2). Keep all wires away from element connections when wires are pushed into free space on right of heater.

STEP 4 Install Grill

Secure grill with the screws provided. Turn power on at the electrical panel board.

FIGURE 2

Fasten screw

Supply leads

Blower wheel

Manual reset button

Heater leads

Grounding

Pigtail

door to prevent someone from turning on power while you are working on the heater. Failure to do so could result in serious electri- cal shock, burns, or possible death.