Cal Spas 6300 Electronic Control Operation, Initial Start-up, Time, Modes, Operating Your Spa

Operating Your Spa

9800 Electronic Control Operation

When first powered up, the 9800 electronic system will perform a self-diagnostic check and then it will automatically heat to and maintain a temperature of 100°F (37.5°C) until you change the set temperature as listed in the “Temperature Adjustment” section below.

These instructions will describe features and options that your particular spa may not be equipped with.

Initial Start-up

When your spa is first powered up, it displays some	Standard Mode: This is programmed to maintain the
configuration codes and then goes into priming mode	desired temperature. Note that the last measured spa
(Pr will appear on the display panel). This mode lasts up	temperature displayed is current only when the pump
to four minutes and then the spa begins to heat to its pre	has been running for at least two minutes. The “STAND”
-programmed temperature of 100°F.	icon will display until the mode is changed.
Temperature Adjustment	Economy Mode: Economy mode heats the spa to the
	set temperature only during filter cycles. The “ECON”
(Range 80°F to 104°F, 26°C to 40°C)	icon will display until the mode is changed. Pressing the
The start-up temperature is set at 100°F (37.5°C). The	“JETS 1” button while in economy mode puts the spa in
last measured temperature is constantly displayed	standard-in-economy mode, which operates the same
on the control panel. Note that the last measured spa	as standard mode but reverts back to economy mode
temperature is displayed. The displayed temperature	automatically after one hour. During this time, pressing
will be updated when the pump has been running for at	the “MODE/PROG” button will revert to economy mode
least two minutes.	immediately.
Press the “UP” or “DOWN” buttons once to display the	Sleep Mode: Sleep mode heats the spa to within 20°F
	(11°C) of the set temperature only during filter cycles. The
set temperature. Each time either button is pressed
	“SLEEP” icon will display until the mode is changed.
again, the set temperature will increase or decrease
	Standby Mode: Pressing “Warm” or “Cool” then “JETS
depending on which button is pressed. After three
seconds, the control panel will automatically display the	2” will turn off all spa functions temporarily. This is helpful
last measured spa temperature.	when changing a filter. Pressing any button resets the
Time	spa.
	Jets 1
When time hasn’t been programmed, the “TIME” icon
flashes. To set the time, press the “TIME” button and	Press the “JETS 1” button once to turn pump 1 on or off
then the “MODE/PROG” button. Use the “UP” and	and to shift between low and high speeds if equipped.
“DOWN” buttons to adjust time. See the next page for	If left running, the low speed turns off after two hours
more detailed instructions.	and the high speed turns off after 15 minutes. On non-
Standard, Economy, Sleep, and Standby	circulation systems, the low speed of pump 1 runs when
	the blower or any other pump is on. It may also activate
Modes	for at least two minutes every 30 minutes to detect the
Mode/Prog: This button is used to switch between	spa temperature and then to heat to the set temperature if
	needed, depending upon the mode. When the low speed
standard, economy, and sleep modes.
	turns on automatically, it cannot be deactivated from the

1.Press “MODE/PROG” to enter mode programming. panel; however, the high speed may be started.

2.Press the “DOWN” button to cycle through to the desired mode.

3.Press “MODE/PROG” to confirm selection.

2008 Portable Spa Owner’s Manual Page 13

LTR20081000, Rev. B