Light

Press the Light button to turn on the light. Press it once again to turn the light off. All optional lighting such as the control panel light and cabinet perimeter lighting is controlled by the Light button and will turn on and off with the spa light.

Option

Press the Option button to turn on the pump 2. Press it once again to turn off the pump 2 (6200 Controls only).

6300 Controls - Pump 2 and Pump 3 Sequence

Press Option button once to activate high speed pump 2.

Press Option button twice to activate high speed pump 3 and high speed pump 2

Press 3 times to activate pump 3 hi speed only

Press 4 times to turn pumps off

Automatic Time outs

These features will automatically turn themselves off during periods of continuous use:

Operating Your Spa

Low speed pump

After 4 hours

High speed pumps

After 15 minutes

Optional circulation pump

After 15 minutes

Optional turbo

After 15 minutes

Spa light

After 15 minutes

Setting Filtration Cycles

Your spa is programmed to filter twice a day. The first cycle will begin 6 minutes after the spa is turned on and the second cycle 12 hours later. The factory has programmed the cycle to last for 2 hours but this can be switched to 4, 6, or 8 hours depending on your requirements. To set filtration time, turn off the power to the spa at the time of day you would like one of the filtration cycles to begin then turn back on after 30 seconds. When power has been restored, press the Temp button then the Jets button. Press Temp button again to change the filtering cycle duration. When desired duration is selected press the Jets button to exit.

At the beginning of each filtering cycle the Turbo system will run for approximately 30 seconds. The low speed pump will run for the duration of the filtering cycle and if an Ozone system is installed it will be activated. During filtering, FC will appear on the main display.

Diagnostic Messages

Message

Meaning

 

--

Spa temperature is unknown. After pump has been running for 2 minutes temperature will be

 

displayed.

 

HH

Overheat protection (spa is shutdown) DO NOT ENTER THE WATER! One sensor has detected

 

118˚F (48˚C) at the heater. Remove the spa cover and allow spa to cool below 107˚F (42˚C).

 

Press any button on the topside display to reset spa. If spa will not reset after spa has cooled,

 

turn off power for approximately 30 seconds and then turn power back on. If display message is

 

repeated then shut the power off to the spa and call your dealer or service organization.

OH

Overheat protection (spa is shutdown) DO NOT ENTER THE WATER! If the spa has reached

 

110˚F (43˚C), remove the spa cover to cool the water. At 107˚F (42˚C), the spa should reset

 

itself. If the spa does not reset, then shut the power off to the spa, wait 30 seconds and restore

 

power to spa. If display message is repeated then shut the power off to the spa and call your

 

dealer or service organization.

IC

A possible ice condition exists within the spa. No action is required, the pump will automatically

 

activate.

 

SA or Sb

Spa is shut down.

Spa has detected that one of the sensors is not operating properly. One

 

of these may display briefly during overheat then disappear when overheat situation has been

 

resolved. Call your dealer or service organization if message does not go away.

Sn

Sensor (Spa is shut down). The high limit or water temperature sensors are not working correctly.

 

Call your dealer or service organization.

 

 

 

2008 Portable Spa Owner’s Manual

Page 11

LTR20081000, Rev. B

Page 13
Image 13
Cal Spas 5100, 6300 Light, Option, Controls Pump 2 and Pump 3 Sequence, Automatic Time outs, Setting Filtration Cycles