6
Operating SpaYour
Operating Your Spa
Electronic Control Operation
Initial Start up
When first powered up, your spa will perform a
1.Press the JETS button to turn on the pump and let it run for 10 seconds. The pump should be running in low speed.
2.Press the JETS buttons again and let the pump run in high speed for 10 seconds.
3.Press the JETS button again to turn off the pump. The pump should be left in the off position for 10 to 15 seconds.
4.Repeat steps 1 through 3 until water is flowing through all the jets and all air is removed from the plumbing.
When the spa has finished priming, the heater will be activated and the water temperature will be maintained in standard mode. The spa will heat to 100°F (37.5°C) at start up until the set temperature is changed as described below.
Temperature Adjustment
(Range 80°F to 104°F, 26°C to 40°C)
The electronic control panel displays the actual wa- ter temperature in degrees Fahrenheit. The displayed temperature will only be current after the pump has been running for at least two minutes.
To display the temperature that the spa is set to:
•Press either the Up or Down button. The tem- perature setting will flash.
•While the display is flashing, each time you press the Up or Down button, the set temperature will change up or down one degree.
Standard, Economy and Sleep Heating Modes
Your new spa is equipped with a heating feature that gives you complete control of the heating system. When the spa is powered up, it will automatically start in standard heating mode.
•St will light briefly on the main display. In this mode, the heating system will automatically main- tain the set spa temperature. In the economy-
heating mode, the heating system will only acti- vate during filtration times.
•Ec will display solid if temperature is not current and will alternate with spa temperature if mea- sured temperature is current.
•Economy mode will heat the water to the set tem- perature while Sleep mode, indicated by a SL on the main display, will also only activate the heater during the filtering cycles but will only heat the water to within 20°F (10°C) of the set tempera- ture. Like Economy mode, SL will display solid when temperature is not current and will alternate with actual temperature when it is current.
Switching Modes
•Press either the Up or Down button followed by the Light button.
•Press the same sequence to switch to the next mode.
Jets
Press the Jets button:
•Once to activate low speed pump.
•Twice to activate high speed.
•Three times to turn pump off.
Light
Press the Light button to turn on the light. Press it once again to turn the light off. All optional lighting such as the control panel light and cabinet perimeter lighting is controlled by the Light button and will turn on and off with the spa light.
2010 Genesis Portable Spa
www.calspas.com | LTR20101058, Rev. B |
