Caldera Highland Series Operating Instructions, Spa-Side Control Operation, Led Display

OPERATING INSTRUCTIONS

SPA-SIDE CONTROL OPERATION

Your spa-side control panel consists of an LED display and convenient touch pads that allow you to set the water temperature and adjust the skim/filter cycle settings, as well as control the hydrotherapy jets, and light from

spa-side.

LED DISPLAY

The LED display on your spa-side control panel continually shows the spa’s actual water temperature. In certain situations, it will also display other messages. See TROUBLESHOOTING section.

TEMPERATURE CONTROL

The set temperature range is from 80°F (27°C) to 104°F (40°C). Higher temperatures can be reached which is indicated by one of these four settings: uT1,uT2, uT3, & uT4. These settings get progressively warmer, with uT4 the highest at approximately 107.5°F (42°C). (Temperatures of any

setting may rise slightly depending on the current use and condition of your spa, and on outside temperature.) To reach the u1-u4 temperature range, press the TEMP

▲button until 104°F (40°C) is displayed, then push down and hold the TEMP ▲ button for 5 seconds until the uT1 is illustrated.

The factory-set temperature is 102°F (39°C). Whenever power is disconnected and then reconnected to the spa, the water temperature will automatically seek this temperature, unless you set it otherwise using the temperature controls.

Pressing the TEMP ▲ button displays the spa’s set temperature. To increase the set temperature, press the TEMP ▲ button again, once for each degree of increased temperature desired. If you hold the button down, the set temperature will increase by one degree every half second. When the set temperature has been reached, the “READY” icon will diplay.

Pressing the TEMP ▼ button displays the spa’s set temperature. To decrease the set temperature, press the TEMP ▼ button again, once for each degree of decreased temperature desired. If you hold the button down, the set temperature will decrease by one degree every half second. When the set temperature has been reached, the “READY” icon will diplay.

JET PUMP CONTROL

Pressing the “JETS” button changes the jet pump functions, depending on the number of presses:

Olympia Spa Model only:

1st press:	Two-speed jet pump runs on low speed
2nd press:	Two-speed jet pump runs on high speed
3rd press:	One-and Two speed jet pumps run on high speed
4th press:	One-speed jet pump runs on high speed
5th press:	Both jet pumps are off.

Cumberland® & AventineTM Spas only:

1st press:	Two-speed jet pump runs on low speed
2nd press:	Two-speed jet pump runs on high speed
3rd press:	Jet pump off

•The pump on high speed automatically turns off after operating for one hour. The pump on low speed automatically turns off after operating for one hour.

•When the jets are active, the JETS icon on the control panel will illuminate.

LIGHT CONTROL

Your Highland spa is equipped with a blue LED light. Press the LIGHT button to turn it on. Press it a second and third time to dim the light to medium and low Press it a fourth time to turn it off. The light automically turns off after six hours. When the light is active, the LIGHT icon on the control panel will illuminate. For enhanced spa enjoyment, an optional six color wheel light feature is available to create your desired ambiance.

10