Califone PA300+ Wired PADM-515, PADM-510, PresentationPro Packages, Inputs, Conditions, Hardware

Accessories

Wired Microphones

PADM-515

Dynamic, balanced, low impedance (50 ohms) with a cardiod pick-up pattern and comes with a 20’ cable with XLR phone plug.

PADM-510

Dynamic, unbalanced, high impedance (500 ohms) with a cardiod pick-up pattern and comes with a 20’ cable with a ¼” phone plug.

Wireless Microphones (for use with PA319 only)

The PA319 is compatible with the Q319 wireless handheld mic. For hands-free operation the M319 Belt Pack transmit- ter may be used with one of the below microphone types.

CM-316flexible collar mic

HBM-316headset mic

LM-316lapel mic

Hardware

TP-30PresentationPro tripod includes its own carry bag.

PresentationPro Packages

Complete wired and wireless packages are also available online

MB-350 Wall/Tripod Mounting Bracket

The MB-350 bracket and accompanying hardware (included) is used to mount the PA319/PA300+ to the TP-30 tripod or for wall mounting. Make sure to have a qualified installation professional install the hardware for wall mounting.

Califone will not be held responsible for any damage resulting from improper installation.

Vi s i t u s o n l i n e a t califone . com

Specifications

Rated power output:	30 watts RMS	at 2% THD
Sensitivity for rated output:	Line:	125 mVrms
	Microphone::	4 mVrms
	Auxiliary:	250 mVrms
Frequency response:	60 Hz – 20 kHz+ 3dB
Treble:	+10dB, -10dB, 10kHz
Bass:	+5dB, -4.5dB 70Hz
Speakers:	Woofer:	6” High efficiency 4oHms, with non inductive external shield
	Tweeter:	2” mylar dome, with crossover capacitor
Crossover:	L/C – 6dB/Octave @ 4kHz
Volume control:	Steps up/down 4.5 dB per step. 10 steps to maximum volume
Inputs
Line inputs (2):	Hi-Z, RCA (summing L+R)
	Balanced mic:	Hi or lo-Z, with phantom power (+15 volts D.C.)
	Unbalanced mic:	Lo-Z, ¼” –phone
	Auxiliary:	Hi-Z Mono ¼” –phone
Line output (2):	750mv constant	2 - RCA, 1 - ¼”
Remote Control distance:	30 Feet
UHF Receiver:	16 selectable channels with switching antennas 902 - 928 MHz
AC Power requirements:	110 – 125 VAC, 50/60 Hz or 208 – 240 VAC, 50/60 Hz
Dimensions (HWD):	6-1/4” x 10” x 8-1/2” (159mm x 250mm x 216mm)
Weight:	Actual weight: 10 lbs	Shipping weight: 14 lbs
Specifications subject to change without notice.

Troubleshooting Guide

Conditions	Possible Solution
No sound (power LED not lit):	Turn POWER switch on plug in power cord
No sound (power LED lit):	Check for output from audio source make sure all cables are completely
	plugged in mic switch on increase volume control
Distorted sound:	Check input cable connection lower input signal level reduce bass and/or treble
Excessive hum or noise:	Use shielded input cable
RC-300 Remote Control does not function:	Replace batteries

NOTE: If further questions, contact our technical repair department at 1(800)722-0500 or (818)407-2400

Vi s i t u s o n l i n e a t califone . com

5 6