Troubleshooting
There is no power
Ensure the AC power cord is connected securely.
Ensure the plug is fully inserted into the wall socket and is switched on. Check fuse in the mains plug or adaptor.
There is no sound
Make sure the unit is not in Standby mode.
Check that source component is properly connected.
Check that TAPE MON is not switched on (unless tape input is required). Check that your speakers are properly connected.
If using Speaker B terminals check they are switched on. Make sure unit is not in mute mode.
There is no sound on one channel
Ensure that balance control is in the correct position. Check speaker connections.
Check interconnects.
There is a loud buzz or hum
Check turntable or tone arm for ground and connection lead fault. Ensure no interconnects are loose or defective.
Ensure that your tape deck/turntable is not too close to the amplifier.
Unable to make or play tape recordings
Check that TAPE MON and TAPE OUT have been connected correctly.
There is weak bass or diffused stereo imaging
Ensure that speakers are not wired out of phase.
Message on display flashing
See section on CAP5 protection system.
The remote handset will not function
Check that the batteries have not expired.
Ensure that nothing is blocking the remote sensor.
For more frequently asked questions (FAQ’s), technical advice and information on getting the most out of your 840A V2, please visit the Support section on Cambridge Audio’s website: www.cambridgeaudio.com/support.php
For all servicing, in or out of warranty, please contact your dealer.
| azur | 840A V2 |
| |
Technical specifications |
| ENGLISH | ||
Power Output | 120W RMS into 8 Ohms | |||
| ||||
| 200W RMS into 4 Ohms |
| ||
THD (unweighted) | < 0.001% 1 kHz |
|
| |
| at 80% of rated power |
| ||
| < 0.01% 20 Hz - 20 kHz |
| ||
| at 80% of rated power |
| ||
Frequency Response | 10 Hz - 50 kHz +/- 1 dB |
| ||
S/N ratio (ref 1W/8 Ohm) | > 93 dB |
|
| |
Input impedances | Input 1 (balanced) 20 kOhm |
| ||
| Inputs |
|
| |
| Tape Input 20 kOhm |
|
| |
Power Amp damping | > 110 at 1 kHz |
|
| |
factor |
|
|
| |
Max power consumption | 800W |
|
| |
Minimum power | Active (no signal) 70W |
| ||
consumption | Standby 7W |
|
| |
Bass & Treble controls | Shelving type |
|
| |
| Max bass boost/cut +/- 10 dB at 10 Hz |
| ||
| Max treble boost/cut +/- 7.5 dB at 20 kHz |
| ||
Dimensions (H x W x D) | 115 x 430 x 385mm |
|
| |
| (4.5 x 16.9 x 15.2”) |
|
| |
Weight | 15.0kg (33Lbs) |
|
|
15