Cambridge Audio azur DacMagic Rear panel connections, Unbalanced Audio Outputs, Digital Outputs

Rear panel connections

Left

1

Right

Unbalanced

Output

DacMagic Upsampling DAC

Designed in the UK, Made in China	www.cambridge-audio.com		4
	3
L	Digital Outputs		Digital Input 1
R
Right — Balanced Output — Left	S/P DIF	Toslink	S/P DIF	Toslink
	Co-axial	Optical	Co-axial	Optical

Caution

Serial Number Label Removed

5

Digital Input 2

S/P DIF	Toslink
Co-axial	Optical

6	Incorporating Q5™ from:
	ANAGRAM
	TECHNOLOGIES

USB In 12V 1500mA

7

Use supplied

PSU only!

	This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
Manufactured in an ISO9001 approved facility	1) This device may not cause harmful interference;
	2) This device must accept any interference, including interference that may cause undesired operation.
2

1Unbalanced Audio Outputs

Single-ended conventional stereo outputs for connection to the line-level phono/RCA inputs of an amplifier.

2Balanced Audio Outputs

The DacMagic also features true balanced (XLR) outputs. This is a higher quality output that can reject noise and interference with equipment with balanced inputs. These balanced outputs are ideally suited for connection to the Cambridge Audio 840A or 840E amplifiers. XLR connectors should be wired as follows:

Pin 1 – Ground; Pin 2 – Hot (in-phase); Pin 3 – Cold (phase-inverted).

3Digital Outputs

The digital outputs allow a digital recording device to be connected. These outputs loop or pass- through unprocessed digital audio from the selected digital input. Two types are available (both the co-axial and the optical are active concurrently and can be used to connect and run equipment at the same time):

S/P DIF co-axial– to obtain best results, use a high quality 75 ohm digital RCA interconnect cable (not one designed for normal audio use).

8